The bolt sensor cone may need to be moved, depending on the door lock
used. You will find the correct position online at
. In
most cases, the cone can remain in the pre-set "Position 1".
Follow the steps below to move the cone:
1. Ensure that the bolt sensor (C) is placed firmly on the installation tool
(D).
2. Simply release the outer ring segment from point X (see image above)
by turning in the direction of the arrow.
3. Move the cone parallel to the axial direction to release it.
4. Pull the cone into the required position.
9
You will find the correct position online at
.
9
Each bar corresponds to a position. The first bar corresponds to the
non-approved zero position. The image shows the cone at Position 1.
5. Turn the ring segment back to its original position until you hear it snap
back into position.
Determining the direction of installation
The door lock must be in the unbolted position when it is installed.
The square opening in the bolt sensor must always point to the right
towards the door hinges when the bolt sensor is fitted. This determines
whether the bolt sensor needs to be fitted from the inner or outer side of
the door.
Fitting the bolt sensor from the inner side
1. Carefully release cable from the bolt sensor (C) cable duct to guide the
plug out onto the inner side.
2. Push the bolt sensor into the profile cylinder opening via the installation
tool (D) until it stops.
9
The square opening in the bolt sensor must always point to the right
towards the door hinges.
3. Rotate bolt sensor 90º, so that the bolt sensor opening points down-
wards.
SmartHandle
(Manual)
7. Installation (manual)
40 / 136
