SmartHandle 3062 must be fitted, so that it is flush with the door. You
must install the product as specified to ensure that it is structurally
stable and will have a long service life.
You must not strike parts of SmartHandle 3062 during installation.
The two inlays in the cover are locked into position with a clip
mechanism. These may only be removed using the SimonsVoss
installation tool.
No water or moisture must penetrate the door or reach the inner side.
Always use the WP version for moisture.
Programme SmartHandle 3062 before installing.
SmartHandle 3062 may be difficult to fit in mortise locks with a
retaining nut. You must not alter the retaining nut in any way, using a file,
for example; otherwise, the handle's guide piece will no longer fit
accurately.
When installing SmartHandle, you must ensure that the cable does not
get caught or fitted too tightly to the door.
Conventional fastening system: When fitting the handle into position on
the door with the two screws, make sure that the electronics are not
subject to mechanical load and are not damaged in any other way.
7.5.4 Installation SKG SmartHandle
These installation instructions are designed for a standard door with a Euro
Profile cylinder door lock already fitted. Old fittings must be fully removed
before SmartHandle 3062 SmartHandle is installed.
IMPORTANT
To ensure full functionality, SmartHandle must always be used in combin-
ation with an SLP lock.
All steps must be completed in order after one another to ensure correct
installation.
SmartHandle
(Manual)
7. Installation (manual)
60 / 136
