4. Pull the installation tool to remove.
9
The bolt sensor remains in the lock. The rectangular opening in the
bolt sensor faces downwards.
Fitting the bolt sensor from the outer side
1. Push the bolt sensor (C) into the profile cylinder opening via the install-
ation tool (D) until it stops.
9
The square opening in the bolt sensor must always point to the right
towards the door hinges.
2. Rotate bolt sensor 90º, so that the bolt sensor opening points down-
wards.
3. Pull the installation tool to remove.
9
The bolt sensor remains in the lock. The rectangular opening in the
bolt sensor faces downwards.
7.2.4.4 Step 3: Preparing to install the outer fitting
1. Place outer cover (2) loosely onto the outer fitting (4). Notice that the
outer cover can only be placed onto the fitting in one direction.
9
The outer cover is positioned flush on the outer fitting but without
fastening it.
2. Push inlay (1) onto the outer handle (3) from the short side. Ensure that
the black side of the inlay is turned towards the door.
3. Insert outer fitting horizontally into the outer fitting in the direction that
you require (DIN left or DIN right).
9
The outer handle is placed in the outer fitting without being
fastened.
4. Position handle fastener piece (5) on the side which will later face the
door, as in the diagram below, and fasten with a spanner in a clockwise
direction (about 75º until you feel resistance).
9
75°
1
2
4
-45°
3
9
The outer handle is now firmly attached to the outer fitting and
cannot be removed from the outside when in use.
5. Check the handle mechanism to ensure it opens easily.
9
The outer handle must return to its home position of its own accord.
Repeat the procedure described in this section if the outer handle
should catch and not open correctly.
IMPORTANT
For easier installation, the cover can also be pushed over the inlay later in
chapter "
Step 6: Fastening the covers [
SmartHandle
(Manual)
7. Installation (manual)
41 / 136
