18. Connect the 3-pole cable from the outer fitting to the 3-pole cable from
the inside fitting. This cable can only be inserted in one direction. Do not
pull on the cables while doing so; just carefully secure the plug-in con-
nection into position.
19. The 2-pole cable from the inside fitting can hang freely, but must not
get caught or buckled when the inside cover is fitted. Do not pull on the
cable. The second cable is optionally used to connect the LockNode cir-
cuit board.
20.Press outer and inside fittings together, so that they are both flush
against the door.
21. Press the electronics module cover lid in the inside fitting (8) carefully
out of its bracket and fold back horizontally. Make sure that the elec-
tronics are not subject to mechanical load and are not damaged in any
other way.
22. Carefully remove the upper battery (10) from the holder. Use clean
gloves free of fat or grease to handle batteries.
23. Insert the supplied screws (9) through drill holes in the inside fitting (8)
from inside the door and fasten to the spacing bolts (7) on the outer fit-
ting by hand, using about 5-7 Nm.
24.Insert the upper battery (10) with the positive terminals facing away
from the door into the brackets; in doing so, insert the batteries under
the black retaining collar first. Use clean gloves free of fat or grease to
handle batteries.
25. Carefully lock the electronics cover lid back into place.
26.Check that the outer handle (3) can turn easily; if it does not, there may
be a problem with the mortise lock (6) or the handle may have been fit-
ted incorrectly. In case of doubt, disassemble components and start
again from Step 10.
27. Push inlay (14) onto the inside handle (11). Depending on the handle
model, it may not be possible to fit it once the handle is installed.
28.Push inside handle (11) onto the inner fitting (8) fastening flange until it
will go no further.
29.Tighten the hexagon screw (12) on the inside handle (11) firmly by hand,
using about 5-7 Nm.
30.Push the cover (13) over the inside handle (11).
31. Carefully push the inlay (14) through the opening in the inside cover (13).
32. Push the cover (13) onto the inside fitting (8), so that it is flush with the
door. The cover is not symmetrical; look carefully at the marking to en-
sure correct positioning (Diagram 7).
33. Click the inlay (14) carefully into the cover (13).
SmartHandle
(Manual)
7. Installation (manual)
49 / 136
