35.Click the inlay (14) carefully into the cover (13).
36.Press the cover plate (15) for the cylinder body carefully into the open-
ing in the inside cover (13).
37. Push the cover (2) over the outside handle (3).
38.Carefully push the inlay (1) through the opening in the outside cover (2).
39.Push cover (2) onto the outer fitting (4), so that it is flush with the door.
The cover is not symmetrical; look carefully at the marking to ensure
correct positioning (Diagram 7).
40
.
Click the inlay (1) carefully into the cover (2).
7.8.6 Diagrams for conventional fastening system
Figure 2:
Handle fastener piece
Figure 3:
Handle fastener piece open
Figure 4:
Handle fastener piece closed
Figure 5:
Fastener piece - correct position for
the handle fastener piece when
closed
Figure 6:
Figure 7:
Tab. 4:
Diagrams showing installation
7.8.7 Storage mode for SwissRound MO
1. Disconnect the 3-pole cable from the inside fitting to the 3-pole cable
from the outer fitting. If necessary also disconnect the cable of the
LockNode from the inside fitting.
2. Hold the inside and outer fittings firmly while pulling them away from
one another horizontally.
3. If necessary, loosen the hexagon screw in the inside door handle, but
ensure that you only unscrew a little, so that the screw remains in the
handle.
4. Remove the inside handle from the inside fitting.
Fitted to the door:
SmartHandle
(Manual)
7. Installation (manual)
83 / 136
