1 x outer fitting
1 x inside fitting
1 x outer handle (including lock ring)
1 x inside handle (including hexagon screw)
1 x mounting screw
1 x fire retardant inlay (in versions for fire retardant doors only)
1 x installation tool for inlay
1 x fastening screw sensor
1 x bolt sensor
1 x Installation tool for bolt sensor
1 x Installation tool for four-wire cable
1x extension cable (2-pole)
(2x for L version for doors over than 79 mm
thickness)
1 x quick start guide
7.2.2 Tools required
The following tools are required for installation are not included in the
delivery:
Allen key (3 mm) to fit handle.
Cross-tip screwdriver type PH2 to fit mounting screw (battery-operated
screwdriver recommended).
19 mm spanner for installing the handle fastener piece.
7.2.3 Installation instructions SnapIn
Batteries are already installed when the product is delivered!
When installing the electronic SmartHandle 3062, ensure that there are
no sources of low-frequency interference in the surrounding area.
SmartHandle 3062 must be fitted, so that it is flush with the door. You
must install the product as specified to ensure that it is structurally
stable and will have a long service life.
You must not strike parts of SmartHandle 3062 during installation.
The two inlays in the cover are locked into position with a clip
mechanism. These may only be removed using the SimonsVoss
installation tool.
SmartHandle
(Manual)
7. Installation (manual)
36 / 136