IMPORTANT
Installation difficulties due to sliders
If you do not fully slide the slider to the home position, you will not be able
to lock the inner cover.
Push the slider completely to the home position!
11. Reapply the inner cover until it is flush with the door.
12. Reapply the inlay.
9
The inlay snaps back into place noticeably.
9
The batteries have been replaced.
13.3 Procedure SmartHandle Hybrid
In January 2016, the battery holder for the hybrid versions was changed to a
black plastic box with cover. Hybrid versions, which were delivered until
January 2016, use two more batteries in the outer fitting in addition to the
two batteries in the inside fitting You must always replace all batteries at
the same time.
Delivery up to January 2016
1. Carefully insert the installation tool from below into the inlay of the in-
ner cover.
2. Slide the installation tool into the inlay to unlock the inlay.
3. Carefully slide the inlay in the direction of the handle.
4. Slide the inner cover in the direction of the handle.
5. Carefully unlock the electronics.
6. Fold the electronics horizontally to the side.
7. Remove all batteries from the holder.
ATTENTION
Mechanical damage due to battery replacement
Pressure on the circuit board can damage the electronics.
Under no circumstances should you exert pressure on the circuit board!
8. Push the new batteries with the positive poles next to each other
quickly into the holder.
9. Fold in the electronics again.
10. Snap the electronics back into place.
SmartHandle
(Manual)
13. Battery replacement
117 / 136
