Siemens HiPath 3000 V3.0 or later Gigaset M1 Professional, Service Manual, Page: 712 / 1202

HiPath 5000 Startup and Administration
P31003-H3560-S403-54-7620, 09/05
6-8
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
start_h5.fm
Software Structure
The following table shows the most important features of the Feature Server.
Presence Manager
This is a Feature Server service for signaling the call processing station states “free”, “busy”
and “call” using the LEDs on the optiset E and optiPoint telephones in a HiPath 3000/5000 net-
work. You can pick up a call by pressing the appropriate button.
Call processing states can only be signaled for a station if the Presence Manager can set a
CSTA monitor point on the relevant station. The status of a MULAP call number cannot be sig-
naled, for example, because a CSTA monitor point cannot be set on a call number of this type.
The dssserver.exe service for the Presence Manager is installed with the HiPath 5000 software.
This is a user-configured service that receives its information from
vaplx.dll
. The TAPI Ser-
vice Provider is required for the Presence Manager to work.
Table 6-1 Feature Server Components
Component Function
vsrv.exe
Basic Feature Server component. As an MS Windows service, it starts all
other components.
vaplx.dll
Logical interface for applications. Provides read-only and read/write access
to CDB data.
cars.exe
The Call Address Resolution Server provides the HG 1500 boards with the
call numbers of all HiPath 3000 systems (nodes) that belong to the net-
work.
Note: Event 1027 confirms that the corresponding HG 1500 board was
successfully downloaded with the call numbers of all HiPath 3000 systems
associated with the network (see Section 12.3.3).
regserv-
er.exe
Following startup, the HG 1500 boards automatically log on to the Feature
Server over the Registration Server.
vsync.exe
All “node-specific” CDB changes (for example, by key programming, Assis-
tant T) are reported by the node to the Feature Server’s VSYNC process.
This ensures the automatic synchronization of the Feature Server with the
new CDB data.
FCT.dll
Interface to the systems for direct CDB data access.
>
Note for troubleshooting and diagnosis
The Feature Server and Presence Manager components generate entries in the
Event Viewer (event log) which are used for troubleshooting and diagnosis.
Section 12.3.3 provides information on the possible entries and any necessary user
responses.