Siemens ADVIA 2400, Operator'S Manual, Page: 54 / 200

54 ADVIA 2400 Operator’s Guide
Sample Select window*
Use this window to select the samples for control sample analysis and calibrations, and to
temporarily disable a sample so that the rest of a run can proceed.
For example, if you only want to run ISE calibration on serum samples, disable the ISE
calibration urine samples. The run proceeds normally, but it does not include urine
samples.
Perform any of the following tasks at this window:
•
select samples available for control analysis calibration
•
print the settings
•
clear the settings
QC Sample Definition window*
Use the QC Sample Definition window for the following tasks:
•
entering the information required to run samples of up to 26 control products
•
requesting an automatic run of control(s) after a user-specified number of samples are
processed
Perform any of the following tasks at this window:
•
enter the sample information for a control
•
configure the automatic control feature
•
print the control sample information
Setup windows
NOTE:
You must log on as a supervisor, tech_manager, or service to access window
under the Setup button.
System Specification Settings window*
Use this window to enter settings related to the system configuration.
You can enter or change settings for the areas listed below:
•
Settings that take effect after the next New Start
•
basic system composition
•
basic system operation
Settings that take effect after startup operation from READY state
•
sample containers
•
reagent bottles
•
Serum indices specifications