CHK
ADJ
Periodic check and adjustment
3-7
6AL3J11
6.
Pour the specified amount of the recom-
mended engine oil into the oil filler hole.
7.
Install the oil filler cap and oil dipstick,
and then start the engine and warm it up
for 5 minutes.
8.
Turn the engine off, and then check the
oil level and that there is no oil leakage. If
the oil level is low, add engine oil to the
correct level.
9.
Install the starboard apron
2
, and then
tighten the apron bolts to the specified
torque.
Replacing the oil filter
CAUTION:
Do not damage the oil pressure sensor
and its lead when replacing the oil filter.
1.
Extract the engine oil with an oil changer
or drain it.
2.
Place a rag under the oil filter, and then
remove the oil filter using a 72.5 mm (2.9
in) oil filter wrench
1
.
NOTE:
•
Wait more than 5 minutes after turning the
engine off to replace the oil filter.
•
Be sure to clean up any oil spills.
3.
Apply a thin coat of engine oil to the O-
ring of the new oil filter.
4.
Install the oil filter, and then tighten it to
the specified torque using a 72.5 mm
(2.9 in) oil filter wrench.
5.
Pour the specified amount of the recom-
mended engine oil into the oil filler hole.
Recommended engine oil:
4-stroke motor oil
API: SE, SF, SG, SH, SJ, or SL
SAE: 5W-30, 10W-30, or 10W-40
Engine oil quantity:
Without oil filter replacement:
5.6 L (5.92 US qt, 4.93 Imp qt)
T
R
.
.
Apron bolt:
8 N
·
m (0.8 kgf
·
m, 5.9 ft
·
lb)
S6S13220
LT
572
LT
572
LT
572
LT
572
2
Oil filter wrench
1
: 90890-06830
T
R
.
.
Oil filter:
18 N
·
m (1.8 kgf
·
m, 13.3 ft
·
lb)
1
S6AL3030
S6AL3040
Summary of Contents for Fin Whale 225 EFI
