SELVA MARINE Fin Whale 225 EFI, Service Manual

Page: 235 / 399

6AL3J11
6-50
1
2
3
4
5
6
7
8
9
NOTE:
Align the insert cartridge projections
a
with
the holes
b
in the pump housing.
6. Install a new O-ring
0
and the pump
housing assembly
A
into the lower case,
tighten the bolts
B
, and then install the
seal
C
and cover
D
.
CAUTION:
Do not turn the drive shaft counterclock-
wise, otherwise the water pump impeller
may be damaged.
NOTE:
• When installing the pump housing, apply
grease to the inside of the insert cartridge,
and then turn the drive shaft clockwise
while pushing down the pump housing.
• Align the cover projection
c
with the hole
d
in the pump housing.
Installing the lower unit
WARNING
When installing the lower unit with the
power unit installed, be sure to suspend
the outboard motor. If the outboard motor
is not suspended it can fall suddenly and
result in severe injury.
1. Align the center of the set pin
a
with the
alignment mark
b
on the bottom cowling
to set the shift lever to the neutral posi-
tion.
NOTE:
If the power unit is installed, the set pin
a
and alignment mark
b
cannot be aligned, so
align the set pin
c
with the alignment mark
d
on the shift bracket.
2. Set the gear shift to the neutral position
at the lower unit.
Shift rod push arm: 90890-06052
Drive shaft and lower case (counter rotation model)