6AL3J11
5-14
1
2
3
4
5
6
7
8
9
NOTE:
•
Apply sealant to the edge of the cylinder
head cover gasket before installation.
•
Tighten the cylinder head cover bolts to the
same torque in both stages.
•
See the exploded diagram (5-7).
19. Check the crank position sensor air gap
k
.
NOTE:
It is recommended to check the crank posi-
tion sensor air gap before installing the wiring
harness guide to improve working efficiency.
20. Install the timing belt guides
6
, and then
adjust the timing belt-to-timing belt guide
clearance
m
.
21. Install the wiring harness guide.
NOTE:
To install the wiring harness guide, see
Chapter 5,
“
Installing the wiring harness.
”
22. Install the spark plugs and ignition coils.
23. Install all parts removed during disas-
sembly.
T
R
.
.
Cylinder head cover bolt:
1st: 8 N
·
m (0.8 kgf
·
m, 5.9 ft
·
lb)
2nd: 8 N
·
m (0.8 kgf
·
m, 5.9 ft
·
lb)
1280B
1280B
1280B
1280B
S6AL5380
S6AL5100
K
Crank position sensor air gap
k
:
1.4
–
1.6 mm (0.055
–
0.063 in)
T
R
.
.
Crank position sensor screw:
4 N
·
m (0.4 kgf
·
m, 3.0 ft
·
lb)
Timing belt-to-timing belt guide
clearance
m
:
1.0
±
0.5 mm (0.04
±
0.02 in)
T
R
.
.
Spark plug:
25 N
·
m (2.5 kgf
·
m, 18.4 ft
·
lb)
Ignition coil bolt:
7 N
·
m (0.7 kgf
·
m, 5.2 ft
·
lb)
S6AL5090
m
m
6
6
6
Power unit (check and adjustment)
Summary of Contents for Fin Whale 225 EFI
