SELVA MARINE Fin Whale 225 EFI, Service Manual

Page: 233 / 399

6AL3J11
6-48
1
2
3
4
5
6
7
8
9
NOTE:
• Be sure to select the pinion shim(s) if
replacing the thrust bearing
2
, drive shaft
housing, drive shaft, or lower case.
• To select the shims, see Chapter 6, “ Shim-
ming (counter rotation model). ”
• To install the pinion nut, push down on the
drive shaft.
4. Install a new O-ring to the drive shaft
housing, and then install the drive shaft
housing into the lower case.
NOTE:
Install the drive shaft housing with the cutout
a
in the housing facing forward as shown.
5. Tighten the pinion nut to the specified
torque.
Installing the propeller shaft housing
1. Set the shift rod joint and dog clutch
1
to
the neutral position as shown.
2. Apply grease to new O-rings and propel-
ler shaft housing.
3. Install a new dowel
2
and the propeller
shaft housing assembly
3
into the lower
case.
4. Install the washer and propeller shaft
housing bolts
4
, and then tighten the
bolts to the specified torque.
5. Install the ring
5
and bolts
6
.
6. Install the water pipe and rubber seals.
Drive shaft holder 6
4
: 90890-06520
Pinion nut holder
5
: 90890-06715
T
R
.
.
Pinion nut:
142 N · m (14.2 kgf · m, 104.7 ft · lb)
S6AL6150
4
5
T
R
.
.
Propeller shaft housing bolt
4
:
30 N · m (3.0 kgf · m, 22.1 ft · lb)
S6AL6510
F
D
R N F
1
2
3
Drive shaft and lower case (counter rotation model)