SELVA MARINE Fin Whale 225 EFI, Service Manual

Page: 202 / 399

LOWR
Lower unit
6-17
6AL3J11
2. Install the washer, spring, thrust bearing
1
, drive shaft, thrust bearing
2
, and
original shim(s)
3
into the lower case.
3. Install the pinion, washer, and pinion nut
temporarily.
NOTE:
• Be sure to select the pinion shim(s) if
replacing the thrust bearing
2
, drive shaft
housing, drive shaft, or lower case.
• To select the shims, see Chapter 6, “ Shim-
ming (regular rotation model). ”
• To install the pinion nut, push down on the
drive shaft.
4. Install a new O-ring to the drive shaft
housing, and then install the drive shaft
housing into the lower case.
NOTE:
Install the drive shaft housing with the cutout
a
in the housing facing forward as shown.
5. Tighten the pinion nut to the specified
torque.
Installing the propeller shaft housing
1. Set the shift rod joint and dog clutch
1
to
the neutral position as shown.
2. Install the propeller shaft shim
2
and
propeller shaft assembly
3
into the pro-
peller shaft housing assembly.
3. Apply grease to new O-rings and propel-
ler shaft housing.
Drive shaft holder 6
4
: 90890-06520
Pinion nut holder
5
: 90890-06715
T
R
.
.
Pinion nut:
142 N · m (14.2 kgf · m, 104.7 ft · lb)
S6AL6150
4
5