SELVA MARINE Fin Whale 225 EFI, Service Manual

Page: 337 / 399

6AL3J11
8-26
1
2
3
4
5
6
7
8
9
3. Connect the 10-pin main harness cou-
pler.
Checking the engine stop lanyard
switch
1. Disconnect the 10-pin main harness cou-
pler.
2. Turn the engine start switch to “ ON, ” and
then check the engine stop lanyard
switch for continuity at the 10-pin main
harness coupler (engine stop lanyard
switch end). Check the wiring harness or
replace the engine stop lanyard switch if
out of specification.
3. Turn the engine start switch to “ OFF. ”
4. Connect the 10-pin main harness cou-
pler.
ECM and electronic throttle valve
control system
8
Checking the throttle valve operation
1. Remove the flywheel magnet cover and
intake silencer.
NOTE:
See the exploded diagram (4-9).
2. Push the throttle valve directly and check
that the valve moves smoothly when the
engine start switch is turned to
“ OFF. ”
3. Turn the engine start switch to “ ON, ” and
then check that the throttle valve oper-
ates smoothly when the remote control
lever is shifted from the fully closed posi-
tion to the fully open position.
4. Turn the engine start switch to “ OFF. ”
5. Install the intake silencer and flywheel
magnet cover.
NOTE:
To install the intake silencer, see Chapter 4,
“ Installing the intake silencer. ”
Switch
position
Lead color
White
(W)
1
Black
(B)
2
Red
(R)
3
Yellow
(Y)
4
Brown
(Br)
5
OFF
ON
START
Switch
position
Lead color
White (W)
1
Black (B)
2
Clip removed
Clip installed
1
2
S6AL8540
OFF
ON
START
OFF
ON
START
S6P24130
Ignition and ignition control system / ECM and electronic throttle valve control system