CHK
ADJ
Periodic check and adjustment
3-5
6AL3J11
Draining the fuel
1.
Reduce the fuel pressure.
NOTE:
To reduce the fuel pressure, see Chapter 4,
“
Reducing the fuel pressure.
”
2.
Remove the cap
1
.
3.
Cover the pressure check valve of the
vapor separator with a rag, and then
press in the pressure check valve using a
thin screwdriver to release the fuel pres-
sure.
4.
Place a drain pan under the vapor sepa-
rator drain hose, and then loosen the
vapor separator drain screw
2
.
5.
Drain the fuel from the vapor separator
drain hose by pressing the pressure
check valve using a thin screwdriver.
WARNING
Reduce the fuel pressure before loosen-
ing the vapor separator drain screw, or
pressurized fuel will spray out and may
result in serious injury.
6.
Tighten the vapor separator drain screw
2
.
Power unit
3
Checking the engine oil
1.
Place the outboard motor in an upright
position.
2.
Remove the oil dipstick, wipe it clean,
and then insert it back into the dipstick
guide.
3.
Remove the oil dipstick again to check
the oil level, and to check the oil for dis-
coloration and its viscosity.
NOTE:
•
Change the oil if it appears milky or dirty.
•
If the engine oil is below the minimum level
mark (L), add sufficient oil until the level is
between (H) and (L).
Changing the engine oil (extracting)
1.
Start the engine, warm it up, and then
turn it off.
2.
Remove the oil dipstick and oil filler cap
1
.
2
1
S6P24310
T
R
.
.
Vapor separator drain screw
2
:
2 N
·
m (0.2 kgf
·
m, 1.5 ft
·
lb)
Summary of Contents for Fin Whale 225 EFI
