6AL3J11
8-18
1
2
3
4
5
6
7
8
9
Ignition and ignition control
system
8
Checking the ignition spark
1.
Remove the ECM cover.
2.
Remove the ignition coils.
NOTE:
To prevent the engine from starting when
cranking it, be sure to remove all of the igni-
tion coils or disconnect all of the injector cou-
plers.
3.
Connect an ignition coil assembly to the
special service tool.
4.
Crank the engine and check the spark. If
the spark is weak, check the ignition sys-
tem.
WARNING
•
Do not touch any of the connections of
the special service tool.
•
Be sure to install the special service tool
to the ignition coil so that sparks do not
leak out.
•
Keep flammable gas or liquids away,
since this test can produce sparks.
NOTE:
The ignition spark can also be checked using
the
“
Stationary test
”
of the YDIS.
5.
Install the ignition coils.
6.
Install the ECM cover.
NOTE:
Connect the injector couplers.
Checking the ignition coil input
voltage
1.
Disconnect the ignition coil coupler.
2.
Turn the engine start switch to
“
ON,
”
and
then measure the input voltage at the
ignition coil coupler (wiring harness end).
Check the wiring harness if below specifi-
cation.
3.
Turn the engine start switch to
“
OFF.
”
4.
Connect the ignition coil coupler.
Checking the crank position sensor
1.
Remove the flywheel magnet cover.
2.
Disconnect the crank position sensor
coupler.
Ignition tester: 90890-06754
S6AL8090
Ignition coil input voltage:
Red/yellow (R/Y)
–
Black (B)
12 V (battery voltage)
R/Y
B
6
4
S6AL8440
2
5
3
1
Wiring harness routing / Ignition and ignition control system
Summary of Contents for Fin Whale 225 EFI
