SELVA MARINE Fin Whale 225 EFI, Service Manual

Page: 361 / 399

6AL3J11
8-50
1
2
3
4
5
6
7
8
9
NOTE:
• Install each planetary gear
M
with its
rounded side facing upward.
• Check the operation of the starter motor
before installing it to the power unit. To
check the operation of the starter motor,
see Chapter 8,
“ Checking the starter motor
operation. ”
Installing the starter motor
1. Install the starter motor to the power unit.
2. Install the wiring harness
1
to the starter
motor, and then fasten the wiring har-
ness
1
and starter motor lead
(brown/white)
3
with the holders
2
.
3. Route the starter motor lead
(brown/white)
3
as shown, fasten it to
the junction box using the plastic ties
4
,
and then install the terminals of the
starter motor lead (brown/white)
7
and
wiring harness lead (brown)
5
using the
same bolt
6
.
NOTE:
To wire the starter motor lead (brown/white),
see Chapter 8,
“ Wiring harness routing. ”
4. Install the starboard intake manifold and
intake silencer.
NOTE:
To install the intake manifold, see Chapter 4,
“ Installing the intake manifold. ”
Charging system
8
Checking the stator coil
1. Remove the starboard intake manifold.
2. Disconnect the stator coil couplers, and
then install the starboard intake manifold.
NOTE:
• When installing the starboard intake mani-
fold at this time, be sure to leave the stator
coil couplers on the outside of the manifold.
• To install the starboard intake manifold, see
Chapter 4,
“ Installing the intake manifold. ”
S6AL8330
M M
M F
K
L
M
M
M L
K
N
S6AL8850
1
2
3
S6AL8870
STBD
4
7 5
6
5
3
Starter motor / Charging system