SELVA MARINE Fin Whale 225 EFI, Service Manual

Page: 53 / 399

6AL3J11
3-4
1
2
3
4
5
6
7
8
9
4. Install the port intake manifold, fuel rail
covers, and flywheel magnet cover.
NOTE:
To install the intake manifold, see Chapter 4,
“ Installing the intake manifold. ”
Checking the fuel filter
1. Disconnect the water detection switch
coupler (blue)
1
.
2. Remove the clamp
2
from the water
detection switch lead
3
, isolator lead
4
,
oil pressure sensor lead
5
, and PTT
switch lead
6
.
3. Remove the fuel filter cup assembly
7
.
NOTE:
•
Do not twist the water detection switch lead
3
when removing the fuel filter cup assem-
bly
7
.
• Be sure not to spill any fuel when removing
the fuel filter cup assembly.
4. Check the fuel filter element
8
. Replace
the fuel filter element if there is dirt or
residue.
5. Check the fuel filter cup assembly
7
.
Clean with straight gasoline if there are
foreign substance or replace if cracked.
NOTE:
•
When cleaning the fuel filter cup assembly,
be sure not to remove the clip
9
and float
0
, otherwise the water detection switch
may be damaged.
• To check the fuel cup for leaks, see Chap-
ter 4,
“ Checking the fuel filter assembly. ”
• Check the water detection switch each time
the fuel filter is checked.
• To check the water detection switch, see
Chapter 8,
“ Checking the water detection
switch. ”
6. Install the fuel filter cup assembly
7
.
NOTE:
Do not twist the water detection switch lead
3
when installing the fuel filter cup assembly
7
.
7. Connect the water detection switch cou-
pler (blue)
1
.
8. Fasten the water detection switch lead
3
, isolator lead
4
, oil pressure sensor
lead
5
, and PTT switch lead
6
with the
clamp
2
.
NOTE:
Be sure to leave a little slack in the water
detection switch lead.
S6AS3010
1
2
6
3
5
4
S6AS3021
7
8
9
0
Top cowling / Fuel system