SELVA MARINE Fin Whale 225 EFI, Service Manual

Page: 306 / 399

BRKT
Bracket unit
7-57
6AL3J11
6. Connect the PTT motor leads
2
to the
battery terminals to fully retract the trim
and tilt rams.
7. Reverse the PTT motor leads between
the battery terminals to fully extend the
trim and tilt rams.
NOTE:
If the rams do not move up and down easily,
push and pull on the trim and tilt rams to
assist operation.
8. Check the fluid level when the trim and
tilt rams are fully extended. If the fluid
level is low, add sufficient fluid, and then
repeat steps 6–7.
Bleeding the PTT unit (built-in)
1. Push the PTT switch to fully tilt the out-
board motor up and down 4 to 5 times.
NOTE:
Connect the PTT motor leads directly to the
battery terminals when the power unit is not
installed. To connect the PTT motor leads,
see Chapter 7, “Bleeding the PTT unit.”
2. Let the fluid settle for 5 minutes with the
outboard motor tilted down.
3. Push the PTT switch to fully tilt the out-
board motor up.
4. Support the outboard motor with the tilt
stop lever, and then let the fluid settle for
5 minutes.
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the PTT unit should lose
fluid pressure.
5. Remove the reservoir cap
1
, and then
check the fluid level in the reservoir.
Ram PTT motor lead
Battery
terminal
Down
Light green (Lg)
+
Sky blue (Sb)
-
Up
Sky blue (Sb)
+
Light green (Lg)
-
S6P23190