6AL3J11
7-24
1
2
3
4
5
6
7
8
9
Removing the PTT unit
1.
Fully tilt the outboard motor up, and then
support it with the tilt stop lever
1
.
WARNING
•
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could
suddenly lower if the PTT unit should
lose fluid pressure.
•
When removing the PTT unit with the
power unit installed, be sure to suspend
the outboard motor. If the outboard
motor is not suspended it can fall sud-
denly and result in severe injury.
NOTE:
If the PTT does not operate, open the manual
valve by turning it counter clockwise, and
then tilt the outboard motor up manually.
2.
Remove the holder
2
, plastic ties
3
,
and PTT motor lead
4
from the holder
5
, and then pull out the PTT motor lead.
3.
Loosen the self-locking nut
6
of the
through tube.
4.
Remove the anode
7
and the PTT unit
bolts
8
(8 bolts), and then move the
clamp brackets slightly in the direction of
the arrows.
WARNING
Do not remove the tilt stop lever
1
from
the clamp brackets.
5.
Remove the circlip
9
and shaft
0
, then
the upper end of the tilt rod from the
swivel bracket.
6.
Remove the PTT unit
A
.
Clamp bracket and swivel bracket
Summary of Contents for Fin Whale 225 EFI
