SELVA MARINE Fin Whale 225 EFI, Service Manual

Page: 166 / 399

POWR
Power unit
5-65
6AL3J11
Checking the crankshaft
1. Measure the crankshaft journal diameter
a
, crankpin diameter
b
, and crankpin
width
c
. Replace the crankshaft if out of
specification.
2. Measure the crankshaft runout. Replace
the crankshaft if above specification.
Checking the crankpin oil clearance
1. Clean the bearings and the connecting
rod.
2. Install the upper bearing into the con-
necting rod
1
and the lower bearing into
the connecting rod cap
2
.
NOTE:
• Install the connecting rod bearings in their
original positions.
• Insert the projection
a
of each bearing into
the slots in the connecting rod cap and con-
necting rod.
3. Put a piece of Plastigauge (PG-1) onto
the crankpin, parallel to the crankshaft.
NOTE:
Be sure not to put the Plastigauge (PG-1)
over the oil hole in the crankpin of the crank-
shaft.
4. Install the connecting rod onto the crank-
pin
3
.
Crankshaft journal diameter
a
:
62.968 – 62.992 mm
(2.4791 – 2.4800 in)
Crankpin diameter
b
:
49.976 – 50.000 mm
(1.9676 – 1.9685 in)
Crankpin width
c
:
21.50 – 21.55 mm
(0.8465 – 0.8484 in)
S6AL5480
Crankshaft runout limit:
0.03 mm (0.0012 in)
S6AL5B10
2
1
a