BRKT
Bracket unit
7-15
6AL3J11
Removing the upper case
1.
Disconnect the ground lead
1
and
speedometer hose
2
.
2.
Remove the upper and lower mounting
nuts
3
, and then remove the upper case
assembly.
NOTE:
•
It is recommended to drain the engine oil
before removing the upper case.
•
Be sure to remove the shift rod assembly
before removing the upper case assembly
from the clamp bracket.
Disassembling the upper case
1.
Remove the engine oil drain bolt
1
,
cover
2
, and damper
3
.
NOTE:
If the engine oil has not already been
drained, place a drain pan under the drain
hole before removing the engine oil drain bolt
1
.
2.
Remove the upper mounts and lower
mounts from the upper case assembly.
3.
Remove the oil pan assembly bolts
4
and
5
, and then remove the oil pan
assembly from the upper case.
NOTE:
The bolt
6
is used to install the lower
exhaust guide onto the upper exhaust guide.
Therefore, if the oil pan assembly will be dis-
assembled after it is removed from the upper
case, also remove the bolt
6
.
4.
Remove the circlip
7
, and then remove
the drive shaft bushing
8
.
S6AL7240
5
4
4
4
6
5
5
0
0
7
A
9
S6AL7250
8
Summary of Contents for Fin Whale 225 EFI
