Sea-doo GTX Limited iS 255 2009, Shop Manual

Page: 220 / 555

Section 03 ELECTRONIC MANAGEMENT SYSTEMS
Subsection 04 (MONITORING SYSTEM AND FAULT CODES)
FAULT
CODE
MODULE DESCRIPTION POSSIBLE CAUSE SERVICE ACTION
C2252 iS TOPS active
Warning only: TOPS
detected by the system,
the suspension is disable
while the TOPS is "ON"
Check for 12 volts on sensor connector
pin A.
Check continuity for circuits B-H1,
B-H3.
Check fuse 10 (refer to
WIRING
DIAGRAM
) refer to the Service Manual
for more details.
C2260 iS System under voltage
System under voltage
warning
Check battery and charging system.
P0106 ECM
Intake pressure
sensor out of range
Sensing port dirty or
blocked.
Sensor failure or
unexpected reading
at idle.
Sensor fallen out of
housing or leaking inlet
Check system circuits A-B4, A-G4,
A-H2.
Make sure that the sensor housing is
correctly inserted into the manifold.
Check sensor connector for:
a) 5 volts on pin 1.
b) 0 volt on pin 2.
c) 0 volt on pin 3.
Refer to the Service Manual
for more details.
P0107
ECM
Manifold absolute
pressure sensor
shorted to ground
Sensing port dirty or
blocked.
Sensor failure or
unexpected reading
at idle.
Sensor fallen out of
housing or leaking inlet
Check system circuits A-B4, A-G4,
A-H2.
Make sure that the sensor housing is
correctly inserted into the manifold.
Check sensor connector for:
a) 5 volts on pin 1.
b) 0 volt on pin 2.
c) 0 volt on pin 3.
Refer to the Service Manual
for more details.
P0108 ECM
Manifold absolute
pressure sensor open
circuit or shorted to
battery
Sensing port dirty or
blocked.
Sensor failure or
unexpected reading
at idle.
Sensor fallen out of
housing or leaking inlet
Check system circuits A-B4, A-G4,
A-H2.
Make sure that the sensor housing is
correctly inserted into the manifold.
Check sensor connector for:
a) 5 volts on pin 1.
b) 0 volt on pin 2.
c) 0 volt on pin 3.
Refer to the Service Manual
for more details.
P0112 ECM
Intake manifold
temperature sensor
shorted to ground
Damaged sensor,
damaged circuit wires,
damaged connector or
damaged ECM pins
Check the sensor for approximately
2280 to 2736 ohms at 19 to 21°C
(66 to 70°F).
Check for approximately 2280 to
2736 ohms at 19 to 21°C
(66 to 70°F) between ECM
connector pins A-H3 and A-J3.
Refer to the Service Manual for more
details.
smr2009-029
197