Section 06 STEERING AND PROPULSION
Subsection 03 (JET PUMP)
smr2009-006-008_a
TYPICAL — MEASURING IMPELLER SHAFT RADIAL PLAY
1. Dial gauge
2. Measure close to impeller hub end
RADIAL PLAY
0 mm (0 in)
Excessive play can come either from worn bearing
or damaged jet pump housing bearing surface.
LEAK TEST
Whenever performing any type of repair on the jet
pump, a leak test should be carry out.
Proceed as follows:
1. Remove impeller cover. Refer to
IMPELLER
COVER
in this subsection.
2. Install the
PRESSURE CAP (P/N 529 036 172)
on
pump housing.
529036172
3. Connect the
VACUUM/PRESSURE PUMP (P/N 529
021 800)
to the pressure cap fitting.
5290218002
smr2008-029-005
TYPICAL
4. Pressurize pump.
LEAK TEST PRESSURE
Maximum 70 kPa (10 PSI)
5. Pump must maintain this pressure for at least
5 minutes.
NOTICE
Repair any leak. Failure to correct a
leak will lead to premature wear of pump com-
ponents.
NOTE:
If there is a pressure drop, spray soapy
water around cover. If there are no bubbles, im-
peller shaft, impeller shaft seal, or jet pump hous-
ing is leaking through porosity and has to be re-
placed. Jet pump unit has to be disassembled.
NOTE:
There may be 2 or 3 bubbles coming out
from the seal on the impeller side. This small leak
is acceptable. Leaks from other areas must be re-
paired.
410
smr2009-039
Summary of Contents for GTX Limited iS 255 2009
