Sea-doo GTX Limited iS 255 2009, Shop Manual

Page: 532 / 555

Section 07 BODY AND HULL
Subsection 03 (HULL)
smr2007-034-110_a
1. Bow eyelet
2. Small washer
3. Nylon washer
4. Loctite 5150 (silicone sealant) here
5. Rubber washer
6. Large washer
7. Elastic stop nut
6. Repair the hole cut in the fixed deck using
the piece cut out during removal. Refer to the
BODY
subsection for fiberglass repair proce-
dure.
NOTE: The previous step is not mandatory if
splash deflector is properly sealed as detailed in
following step.
7. Apply a bead of
LOCTITE 5150 (SILICONE
SEALANT) (P/N 293 800 086)
to the inside of
the splash deflector as in following illustration.
smr2009-043-028_a
APPLY SILICONE HERE
8. Reinstall the splash deflector on the fixed deck.
STERN EYELETS
Stern Eyelet Removal
1. Open boarding platform and remove the appli-
cable storage tray.
2. Inside hull, unscrew and discard elastic stop
nuts securing the stern eyelet to hull.
3. Pull stern eyelet to remove it from watercraft.
4. Clean any residue of silicone sealant from the
hull.
Stern Eyelet Installation
1. Install small washers and nylon washers to
stern eyelet and insert it through the hull.
2. Inside hull, apply
LOCTITE 5150 (SILICONE
SEALANT) (P/N 293 800 086)
all around holes.
3. Install eyelet and other parts using NEW elastic
stop nuts as per following illustration.
smr2007-034-112_a
1. Stern eyelet
2. Small washer
3. Nylon washer
4. Loctite 5150 (silicone sealant) here
5. Rubber washers
6. Large washers
7. Elastic stop nuts
4. Torque retaining nuts to 14.5 N•m (128 lbf• in ).
HULL INSERTS
Metal inserts (brass) of various types and sizes
are screwed into the hull at various locations. A
threaded hole in the insert is used for fastening
various parts and equipment onto the hull (engine
mounts, battery mounts, ride plate, sponsons,
etc).
Some inserts pass completely through the hull,
while others do not (blind hole inserts). Some are
designed to accept an M6 screw while others an
M8 screw.
smr2009-042
509