Sea-doo GTX Limited iS 255 2009, Shop Manual

Page: 19 / 555

INTRODUCTION
FASTENER INFORMATION
SELF-LOCKING FASTENERS
PROCEDURE
A00A6LA
TYPICAL — SELF-LOCKING FASTENER
The following describes the most common appli-
cation procedures when working with self-locking
fasteners.
Use a metal brush or a tap to clean the hole prop-
erly then use a solvent, let act during 30 minutes
and wipe off. The solvent utilization is to ensure
the adhesive works properly.
LOCTITE ® APPLICATION
PROCEDURE
The following describes the most common ap-
plication procedures when working with Loctite
products.
NOTE: Always use proper strength Loctite prod-
uct as recommended in this shop manual.
Threadlocker Application for
Uncovered Holes (Bolts and Nuts)
A00A3LA
1
2
1. Apply here
2. Do not apply
1. Clean threads (bolt and nut) with solvent.
2. Apply
LOCTITE PRIMER N (P/N 293 800 041)
on
threads and allow to dry.
3. Choose proper strength Loctite threadlocker.
4. Fit bolt in the hole.
5. Apply a few drops of threadlocker at proposed
tightened nut engagement area.
6. Position nut and tighten as required.
Threadlocker Application for Blind
Holes
1
2
lmr2007-040-004_a
1. On threads
2. On threads and at the bottom of hole
1. Clean threads (bolt and hole) with solvent.
2. Apply
LOCTITE PRIMER N (P/N 293 800 041)
on
threads (bolt and nut) and allow to dry for 30
seconds.
3. Choose proper strength Loctite threadlocker.
4. Apply several drops along the threaded hole
and at the bottom of the hole.
5. Apply several drops on bolt threads.
6. Tighten as required.
Threadlocker Application for Stud in
Blind Holes
2
1
3
lmr2007-040-005_a
1. On threads
2. On threads and in the hole
3. Onto nut threads
1. Clean threads (stud and hole) with solvent.
XVI
smr2009-011