Sea-doo GTX Limited iS 255 2009, Shop Manual

Page: 411 / 555

Section 06 STEERING AND PROPULSION
Subsection 02 (iBR AND VTS)
smr2009-038-028_a
1. Read Data
2. Activation page tab
3. iBR tab
6. Select the iBR UP and iBR DOWN s alternately
and look for a change in iBR Position (Deg) .
smr2009-038-028_b
1. iBR UP/DOWN s
2. iBR position indication
If the iBR moves using these s but does not move
using the iBR lever, refer to
BRLS VOLTAGE TEST
in this subsection.
If the iBR does not move, check the iBR fuse in
FB2. If fuse is good, refer to
iBR ACTUATOR IN-
PUT VOLTAGE TEST
in this subsection.
iBR Actuator Motor Current Test Using
B.U.D.S.
1. On the iBR activation page in B.U.D.S., note the
iBR Position (Deg) indication.
smr2009-038-029_a
1. iBR position indication
2. Press and hold the VTS UP button on the LH
handlebar to position the iBR to the full up po-
sition and look for the
iBR Motor Current indi-
cation in B.U.D.S. Also look for a change of iBR
Position (Deg) indication.
NOTE: Current draw indication will not be stable.
High and low peaks will be observed. Look for the
maximum average current draw.
smr2009-038-032_b
Step 1: Note iBR current draw
Step 2: Note iBR position indication change
3. Press and hold the VTS DOWN button and look
for the iBR Motor Current draw indication.
Also look for a change of iBR Position (Deg)
indication.
388
smr2009-037