Sea-doo GTX Limited iS 255 2009, Shop Manual

Page: 515 / 555

Section 07 BODY AND HULL
Subsection 02 (BODY)
ssi2009-003-030
15. Lock the end of rope as shown.
ssi2009-003-031
16. Install rewind unit into housing.
16.1 Install the rewind unit with the retaining
screw downward. The end of rope must
be placed in front of the housing opening.
16.2 Insert spring in shaft notch.
ssi2009-003-032_a
1. Spring in notch
NOTE: Ensure spring is properly inserted in
notch.
17. Using a screwdriver, crank rewind spring ex-
actly 7 turns (clockwise).
ssi2009-003-033_a
18. Unlock the end of the rope and pull it out by
the housing opening.
NOTE: Be careful not to release the rope and the
spring. Otherwise you will need to remove drum
and repeat the cranking operation.
19. Install locking mechanism and rope.
19.1 Pull out rope end.
19.2 Insert end of rope through locking mech-
anism.
ssi2009-003-034_a
1. Locking mechanism
19.3 Pass rope end through the rope button
and tie a knot on the rope end, see pic-
ture.
ssi2009-003-035_a
1. Rope
A. 18 mm ± 6 mm (23/32 in ± 15/64 in)
19.4 Pull knot in the button and install the
button cap. Make sure cap is properly
snapped.
20. Install Speed-Tie cover. Tighten screws to
0.9 N•m ± 0.1 N•m (8 lbf•
in ± 1 lbf• in ).
492
smr2009-042