Sea-doo GTX Limited iS 255 2009, Shop Manual

Page: 445 / 555

Section 06 STEERING AND PROPULSION
Subsection 03 (JET PUMP)
smr2009-006-019_a
TYPICAL
1. Threads
2. Seal lip contact surface
3. Threads
Inspect ball bearing for corrosion.
Impeller Shaft and Bearing Installation
Bearing Installation
The installation is essentially the reverse of the re-
moval procedure. However, pay attention to the
following.
1. Using the
IMPELLER SHAFT BEARING TOOL
(P/N 529 036 168)
on the bearing inner race,
press the bearing on the impeller shaft.
2. Use the
IMPELLER SHAFT PUSHER (P/N 529 035
955)
to protect the impeller shaft threads.
NOTE: The bearing can be installed in either direc-
tion.
smr2009-006-013_a
TYPICAL
1. Impeller shaft bearing tool on INNER race
2. Impeller shaft and bearing
3. Impeller shaft installer/pusher tool
3. Press bearing until it bottoms.
Impeller Shaft Installation
NOTE: Ensure there is no O-ring in pump housing
on the cover side.
1. From the outlet side of pump, press impeller
shaft assembly into housing using the
IM-
PELLER SHAFT BEARING TOOL (P/N 529 036
168)
.
smr2009-006-014_a
TYPICAL
1. Bearing tool
2. Impeller shaft and bearing
2. Press bearing until it bottoms.
NOTE: Ensure impeller shaft turns freely and
smoothly.
3. Turn pump upside down.
4. Coat shaft surface with
JET PUMP BEARING
GREASE (P/N 293 550 032)
.
5. Install O-ring at bottom.
1
F19J07A
2
TYPICAL
1. O-ring at bottom
2. Coat surface
6. Apply 4 ml (.1 U.S. oz) of
JET PUMP BEARING
GREASE (P/N 293 550 032)
on bearing.
422
smr2009-039