Section 07 BODY AND HULL
Subsection 02 (BODY)
ssi2009-003-010_a
1. Rear locking tab
2.3 Lightly pull the top of LH trim and insert
the reel of the Speed-Tie unit in its location
as shown.
NOTE:
Insert the unit with the marking out-
side.
ssi2009-003-011_a
1. Speed-Tie unit reel
NOTICE
During Speed-Tie unit insertion,
be careful not to damage the LH trim.
3. To facilitate the locking mechanism insertion,
temporarily pull approximately 200 mm (8 in) of
rope between reel and locking mechanism.
4. Position the reel to the bottom of its cavity.
ssi2009-003-012_a
1. Push in the reel
5. Lift the lever and insert the locking mechanism
so that the lever is pointing toward the front of
vehicle.
ssi2009-003-013_a
1. Locking lever
2. Rope
6. Align the reel with the locking mechanism
and secure them using four M6 x 45 tapered
screws.
7. Tighten
screws
to
4 N•m ± 1 N•m
(35 lbf•
in
± 9 lbf•
in
).
ssi2009-003-014_a
1. M6 x 45 tapered screws
8. Install the cam trim.
8.1 Insert both cam trim retaining hooks into
locking mechanism openings.
ssi2009-003-015_a
1. Retaining hooks
8.2 Press down the cam trim until it snaps into
place.
smr2009-042
487
Summary of Contents for GTX Limited iS 255 2009
