Sanyo MCO-19M, Service Manual

Page: 63 / 187

- 60 -
㻌
㻌
㻌 㻌 㻌 㻌
<Initial data in non-volatile memory>
Data Initial Remark
Set temperature
37.0
䉝
Set O2 density 20.0%
Set CO2 density 0.0%
Ring Back time 30 min.
Temperature zero calibration
0.5
䉝
Log interval 6 min.
CO2 zero calibration 500 Corrective coefficient
CO2 span calibration 700 Corrective coefficient
CO2 sensor gas cell voltage 4000mV For CO2 zero calibration
Key Lock 0 0:OFF
1:ON
24hours UV mode 0 0:OFF, 1:ON
DAQ mode 0 0:Local
1:Remote
Remote alarm 1 0:Linked with buzzer
1:Not linked with buzzer
LCD backlight 0 0:Blue, 1:White
CO2 sensor gas reference voltage 4000mV For CO2 zero calibration
Model code 0
Function doe 0
DAQ communication speed 0 0:2400bps
1:4800bps
2:9600bps
DAQ communication ID 0
High/low temperature alarm
±1.0
䉝
High/low CO2 density alarm ±1.0%
High/low O2 density alarm ±1.0%
Alarm delay time 15 min.
Dooer alarm delay time 2 min.
UV lamp timer 0 min.
Door heater balance 6 Current conductivity ratio
Bottom heater balance 10 Current conductivity ratio
Key lock password 0000
CO2 valve control 0 0: CO2 valve A
1: CO2 valve B
N2/O2 valve control 0 0: O2/N2 valve A
1: O2/N2 valve B
PCB test mode 0 0:OFF, 1:ON
Demo mode 0 0:OFF, 1:ON
CO2 Auto changer mode (option) 0 0:OFF, 1:ON
Standard gas calibration (option) 0 0:OFF, 1:ON
H2O2 decontamination (option) 0 0:OFF, 1:ON
UV lamp option 0 0:OFF, 1:ON
Primary H2O2 misting time 7 min.
Primary H2O2 preservation time 0 min.
Secondary H2O2 misting time 0 min.
Secondary H2O2 resolution time 90 min. UV resolution
UV lamp accumulation time 0 min.
Standard gas CO2 density 5.0%
Standard gas o2 density 5.0%
H2O2 decontamination temperature
45.0 䉝
O2 zero calibration 500 Corrective coefficient
O2 span calibration 500 For N2 mode
500 For O2 mode
O2 sensor gas cell voltage 200mV For O2 zero calibration
㻌