Sanken SVCO6, Instruction Manual, Page: 288 / 326

- 286 -
7-4 Serial Communication Function
In RAM bit status, the status flags are shown as follows.
And, the ―only vector mode‖ bit is reset and cleared only in vector mode; all the bits will be cleared in V/f mode.
(Clear = 0, Reset = 1)
FL-STFLG bit formation
Vslow JOG
DC braking
Braking excitation (only vector mode)
Starting excitation (only vector mode)
Stop deceleration
Raising frequency
Lowering frequency
Matching frequency
Matching speed (only vector mode)
Reverse run
Gate ON (during operation)
Frequency locked
Standby
※
b13
-
b31 is system reserved.
2
）
Continuous register writing
· 06H: One register writing / 10H: Continuous register writing
· With continuous register writing, the data listed in the following table can be written.
For setting errors of function codes, please refer to list of error codes.
Note: The data format of all function codes are the same with dedicated communication protocol.
However, F5001 (poles, voltage and capacity) is consisted by the following data.
Data length: 16bit
bit15 - bit8: capacity
bit7 - bit4: voltage
bit3 - bit0: number of poles