Sanken SVCO6, Instruction Manual, Page: 157 / 326

- 155 -
C
h
ap
ter
7
7-3 Description of Functions
F1509 Selection of output terminal DO1
F1510 Selection of output terminal DO2
F1511 Selection of output terminal DO3
This function is used to select the required function from the multifunctional output terminals DO1-DO3 of control circuit
terminals to execute open-collector output.
Code No. Function Name Data Content Setting
Resolution
Factory
Presets
F1509
F1510
F1511
Selection of output
terminal D01
Selection of output
terminal D02
Selection of output
terminal D03
0: Unused 1: In operation 1
2: Undervoltage
3: End of simple scheduled operation
4: In operation 2
5: Frequency matching (1st speed frequency)
6: Frequency matching (1st to 16th speed
frequencies)
7: Frequency arrival
8: Overload alarm level setting signal (the
value of F1704)
9: Electric thermistor pre-alarm signal
(80% of electric thermistor)
10: Radiator overheat pre-alarm signal
13
：
Excitation and DC braking signals
14
：
Lower frequency limit matching signal
15
：
Upper frequency limit matching signal
16: Servo on ready signal
17: Zero servo completion signal
18
：
FR signal 19
：
RR signal
20
：
2DF signal 21
：
3DF signal
22
：
5DF signal 23
：
9DF signal
24
：
AD2 signal 25
：
AD3 signal
26
：
JOG signal 27
：
MBS signal
28
：
ES signal 29
：
RST signal
31: Positioning completion signal
32: Discharge resistor on signal
34: Frequency counter (output frequency)
(*1)
35: Frequency counter (command frequency)
(*1)
36: Overload alarm level setting signal
(Including when in acceleration/deceleration )
42: Torque matching signal
43: Low speed detection signal
47: Motor speed counter (*1)
48: Forward run detection signal
49: Reverse run detection signal
59: Low torque order 60: Alarm
61: In FWD operation (Only 3wired operation)
62: In REV operation (Only 3wired operation)
1 1
5
8
*1 Can not be used together with the current output function. When outputting frequency counter, set F1515 = 0 to disable the
current output function.