Samson 3730-6, Mounting And Operating Instructions

Page: 93 / 124

Code
no.
Parameter
– Readings,
values [default setting]
Description
Note: Codes with marked with an asterisk (*) must be enabled with Code 3 prior to configuration.
37 Options
Read only
Indicates which option (connected to terminals 31 and 32,
Fig. 18) is installed:
No:
No option installed
POS: Analog position transmitter
dI: Binary input
LS: Leakage sensor
When the binary input is used, DI and HIGH or LOW status are
displayed in alternating sequence.
When the leakage sensor is used,
LS and the detected sound
level in dB are displayed in alternating sequence.
38* Inductive limit switch
[No] · YES · ESC
Indicates whether the inductive contact option is installed.
39 Set point deviation e
Read only
Shows the set point deviation (e = w – x)
40 Min. transit time OPEN
Read only
Minimum opening time determined during initialization
41 Min. transit time CLOSED
Read only
Minimum closing time determined during initialization
42 Set point
Read only
Set point w applied for automatic mode
4 to 20 mA corresponds with 0 to 100 %
43 Firmware version
Read only
Device type and current firmware version (displayed in alter-
nating sequence)
44 Info y
Read only
Control signal y in %, in relation to the travel range determined
during initialization
MAX: The positioner builds up its maximum output pressure.
See description for Code 14, 15 .
0 P: The positioner vents completely. See description for Code
14, 15 .
– – –: The positioner is not initialized.
EB 8384-6 EN
93
Code list