57
Input channel operations
Input channel operations
Use the AUX SENDS area of the CHANNEL EDIT section to perform
these operations.
fig.ChEdtAux.eps
You can adjust the send level in either of two ways: using the SEND
LEVEL knob of the AUX SENDS area, or using the faders of the top
panel.
Using the SEND LEVEL knob
1.
Press AUX SELECT [1]–[16] to select the send-destination
AUX bus.
2.
Use the SEND LEVEL encoder to adjust the amount sent to
the selected AUX bus.
You can make fine adjustments by holding down [SHIFT] while
you operate SEND LEVEL.
You can turn the corresponding send switch on/off by holding
down [SHIFT] and pressing AUX SELECT [1]–[16].
Using the top panel faders
(SENDS ON FADER)
1.
Press AUX SELECT [1]–[16] to select the send-destination
AUX bus.
2.
Press [SENDS ON FADER] so it is blinking.
3.
Use the top panel faders to adjust the amount sent from
each input channel to the selected AUX bus.
fig.FaderAll.eps
By pressing [DISP] you can access the AUX SENDS popup,
where you can make detailed settings for AUX send. For details,
refer to “AUX send operations” (p. 111).
Sending the audio signal to the
AUX buses
SENDS ON FADER is a convenient function, but involves
the risk of unintended mistakes. Operate the faders with
care while [SENDS ON FADER] is blinking.
M-400_v15_e.book 57 ページ ２００８年６月２０日 金曜日 午後４時５分
