Ricoh V-C3 D081, Field Service Manual

Page: 152 / 1092

• You must use the M4 x 14 screws.
6. Attach the rear docking plate [C] ( x2). These are the docking plates for the next device to be
installed in the paper feed line.
• You must use the M4 x 14 screws.
7. Attach the black mylar [A] to the relay guide plate [B] of the next finishing device to be installed to
the left of the cover interposer tray.
• Do not attach this mylar to either the long or short guide plates provided with the cover interposer
tray accessories.
.
8. Peel the tape from the back of the sponge strip [A] and attach it as shown.
9. Attach the relay guide plate [B] ( x2).
• You must use the Relay Guide Plate – Short (12-in.)
10. Remove the ground plate [C] from the bottom cross-piece ( x2).
11. Turn the ground plate over.
12. Reattach the ground plate with the same screws as shown ( x2).
2. Installation
150
2