Ricoh V-C3 D081, Field Service Manual

Page: 81 / 1092

• If 'Failed' appears immediately after you start SP3811-1, the machine has not warmed up. Wait
2 minutes, and then do SP3811-1 again.
• Do SP3811-1 only once. Executing SP3811-1 more than once can cause toner spill inside the
machine. SP3811-1 initializes not only the TD sensor but initializes the developer as well.
• SP3811 does a number of things, including initialization of the TD sensor. You must not initialize
the TD sensor again. Do SP3811-1 only once. SP 3801 also initializes the TD sensor.
• Never do SP3801-1 (Init TD Sensor) after doing SP3811. If the TD sensor is initialized twice this
will cause a fatal error in toner supply control.
6. When the message tells you that the initialization is completed, touch [Close].
7. Do SP3812-1 to confirm that SP3811-1 executed correctly.
• If you see "1111" (K M C Y), this means SP3811-1 executed correctly.
• If you see any number other than "1111", this means an error. (See SP3812 Errors.)
• For a complete list of errors and how to solve problems related these SP codes and light images,
please see "Special Procedures" in the Troubleshooting section..
8. Do SP 3821-1 to check that process control was completed successfully.
• For each color, there is a two-digit code, in the order K,M,C,Y. '10' means that process control
was completed successfully. '10101010' means that all 4 colors completed process control
successfully.
Load the Paper Trays
For each paper cassette tray:
1. Move the side fence and bottom fence to the correct positions for the paper.
2. Add paper to the trays.
3. Attach the paper size decals to the front of the three trays.
• It is not necessary to input the paper size setting for trays 2 and 3. This is detected automatically.
Make a Test Color Print
1. Make sure that A3 or DLT paper is in one of the trays.
• Use the same type of paper that the customer normally uses for color outputs.
2. Put a "Color Chart C-4" on the exposure glass.
Main Machine D081/D082
79
2