Ricoh V-C3 D081, Field Service Manual

Page: 626 / 1092

No. Component Function
SOL7
Front Side Fence Solenoid
–Tray 1
When the right tray paper sensor in the tandem tray signals
paper out, and the left tray paper sensor signals paper present,
this energizes this solenoid which pulls open the front side fence
until the front side fence open sensor detects the actuator of the
front side fence and switches off the solenoid, leaving it locked
in the open position, to allow the rear fence to push the paper
stack from the left tray into the right tray.
SOL8
Rear Side Fence Solenoid –
Tray 1
When the right tray paper sensor in the tandem tray signals
paper out, and the left tray paper sensor signals paper present,
this energizes this solenoid which pulls open the rear side fence
until the rear side fence open sensor detects the actuator of the
rear side fence and switches off the solenoid, leaving it locked
in the open position, to allow rear fence to push the paper stack
from the left tray into the right tray.
SOL9
Right Tray Lock Solenoid –
Tray 1 Releases the lock lever when the left tray paper sensor in the
tandem tray signals that there is no paper in the left tray.
SOL10
Left Tray Lock Solenoid –
Tray 1
When the rear fence motor in the tandem tray switches on, this
energizes the left tray lock solenoid. This locks the left tray so
it does not move while the rear fence pushes the stack from the
left tray to the right tray.
SOL11
Duplex Junction Gate
Solenoid Controls the opening and closing of the duplex junction gate
at the mouth of the inverter unit.
SOL12
Reverse Trigger Roller
Solenoid After a sheet is detected by the duplex entrance sensor, this
solenoid energizes and pushes down the reverse trigger roller.
SOL13 Guide Plate Solenoid
Energizes when a jam occurs between the vertical transport
rollers and registration roller to force the guide plate open and
divert paper fed from below into the duplex tray.
SOL14
Inverter Junction Gate
Solenoid
Operates the inverter junction gate. The inverter injunction gate
turns paper into the path to the inverter unit below where it is
1) inverted for face–down output or 2) inverted for 2nd side
printing.
SOL15 Bypass Pick–up Solenoid
Switches on and lowers the pick–up roller to the top of the stack
in the bypass tray
SOL16
Charge Cleaning Solenoid:
Y
Raises and lowers the Y charge roller cleaning roller.
1. Appendix: Specifications
48
1