Ricoh V-C3 D081, Field Service Manual, Page: 566 / 1092

Level Definition Reset Procedure
D
Turning the operation switch (or main power switch)
off then on resets these SCs. These SCs are displayed
on the operation panel and displayed again if the
error reoccurs. Turn the operation switch (or main
power switch) off and on, or the
machine reboots automatically. (See
below.)
When a Level "D" SC code occurs
When a Level D SC occurs, a screen opens on the operation panel to tell the operator:
• An error occurred
• The job in progress will be erased
• The machine will reboot automatically after approximately 30 seconds.
The operator can wait until the machine reboots automatically or touch "Reset" on the screen to reset the
machine immediately and go back to the copy screen.
If the operator does not touch "Reset"
The next message tells the operator that the machine will reset automatically and that the previous job was
lost and must be started again. After reading the message, the operator touches "Confirm" on the screen.
The next screen shows the number and title of the SC code, and stops until the operator turns the machine
off and on.
If the operator touches "Reset"
If the operator touches "Reset" to bypass the 30-second interval for the machine to reboot, the machine
reboots immediately and the operation panel displays the copy screen.
• Do not try to use the operation panel during an automatic reboot. If the @Remote Service System is
in use, the SC code is sent immediately to the Service Center
SC Code Descriptions
Before You Begin…
• If a problem concerns a circuit board, disconnect and reconnect the connectors and then test the
machine. Often a loose or disconnected harness is the cause of the problem. Always do this before
you decide to replace the PCB.
• If a motor lock error occurs, check the mechanical load before you decide to replace the motor or
sensors.
• When a Level "A" or "B" SC occurs while in an SP mode, the machine cannot display the SC number.
If this occurs, check the SC number after leaving the SP mode.
6. Troubleshooting
564
6