Ricoh V-C3 D081, Field Service Manual

Page: 492 / 1092

4. Slowly loosen the front lock screw [C] until you see the tip of the shaft (1) aligned with the hole (2),
then tighten the screw.
• To avoid stripping the threads of the screws, do not apply excessive force.
5. Remove the special tool and fit it onto the rear (see above).
• If the Teflon sleeve has been reattached at [D], remove it. Do not reattach the sleeve until after
adjusting the belt tension. (The special tool does not fit over the rear end with the Teflon sleeve
attached.)
6. Slowly loosen the rear lock screw [E] until you see the tip of the shaft (3) aligned with the hole (4),
then tighten the screw.
7. Re-attach the Teflon sleeve.
8. Re-attach the front and rear plastic cover.
9. Re-attach the transport belt assembly in the ADF.
Reattaching the White Cover
1. With its white side down, set the cover [A] on the exposure glass.
2. Make sure the upper left corner is aligned with the arrow at the corner of the exposure glass.
3. Close the ADF [B].
4. Replacement and Adjustments
490
4