PAGE 82
OPERATOR’S MANUAL ULTRA GUIDANCE PSR ISO
CHAPTER
PSR SKY
5.8.
Implement offset setting
The offset correction is needed when the implement is not cen-
tered on the steered vehicle.
Test this by driving 3 passes. The operator may notice overlap on
one side, and a skip on the other side of the center pass (see ad-
jacent figure).
To correct this offset in the steering system, measure the width
of the skip.
Choose
and confirm the selection.
Press the function keys
,
to enter the previously
measured value. Alternatively, you can also set the value manually
as described in chapter 4.11.
•
Offset to the right means the skip is on the left (in driving
direction). Then enter the measured distance with a (–) in front.
•
Offset to the left means the skip is on the right (in driving
direction). Then enter the measured distance with a (+) in front.
Press and hold the function key
until the stored symbol
appears. Proceed as described in chapter 4.12.
Track 1
Track 2
Track 3
Picture 137:
Demonstrate offset left/right
overlap
gap
Picture 138:
Implement offset setting
Picture 139:
Setting offset left or right