PAGE 18
OPERATOR’S MANUAL ULTRA GUIDANCE PSR ISO
CHAPTER
INSTALLATION OF SYSTEM COMPONENTS
3.2.
Installation of PSR iBox
A portion of the vBasic is the mounting bracket of the PSR iBox.
It will be permanently installed in the vehicle and is available for
further usage.
Advice!
In order to protect the connectors from moisture
and dirt, and assure optimum contact during the next
operation, always screw on blind caps and plugs (see
adjacent figure).
The PSR iBox is easily installed by following these instructions:
1. Insert the tabs on the upper edge of the mounting bracket into
the cut-out’s on the backside of the PSR iBox (see Picture 6).
2. Flip the PSR iBox down (see Picture 7).
3. Grab the latch and insert the hook into the slot provided (see
Picture 7) and rotate the latch (see Picture 8) to lock.
4. Insert the cable connectors X
A
and X
B
into the bottom of the
PSR iBox.
5. Make sure that both cables X
A
and X
B
are
properly inserted and locked with the
locking slide provided.
Attention!
Make sure that the latches on both sides of
the PSR iBox are tightly connected to the mounting
bracket.
Picture 5:
Mounting plate PSR iBox
Picture 6:
Step 1: Positioning
Picture 7:
Step 2: Inserting
Picture 8:
Step 3: Locking
