PAGE 68
OPERATOR’S MANUAL ULTRA GUIDANCE PSR ISO
CHAPTER
PSR SKY
•
Lat/Lon = entry of coordinates of points A and B.
Select the button “W-width” to set your working width.
Select buttons “Point A” and “Point B” to enter the current
coordinates.
•
Lat/Lon + Heading = entry of coordinates of points A and B,
entry of compass direction
Select the button “W-width” to set your working width.
In the “Heading” display, select the exact compass direction in
which you wish to drive. As an alternative, you can specify the
compass direction by homing in on a certain point and driving
towards it. Confirm the selection as soon as the heading is correct.
Select button “Point A” to enter the current coordinates.
Advice!
It is recommended to use two corners of the
field as A and B points. The larger the distance be
-
tween the two marker points the more exact the refer-
ence line. A distance between points A and B which is
less than 60 ft is not acceptable to the system.
Advice!
We recommend using “A + Heading” and “Lat/
Lon + Heading” only when the exact compass direction
is known.
In this system the compass direction of the reference
line is also stored with each job.
Stop the vehicle when you want to readjust the heading
in which you wish to drive.
Advice!
The Set W-width function is only possible if
“AT” (asynchronous tracks) is switched off.
Picture 106:
New job (Lat/Lon)
Picture 107:
New job (Lat/Lon + Heading)