Qiagen QIAgility, User Manual

Page: 321 / 334

Appendix F
QIAgility User Manual 11/2011 F-9
8. When ready, click the “Start” button to commence
automatic height calibration. Where the segment
contains vessels eligible for optimal calibration, the
system uses a tip to probe the base of the vessel,
discards it, then uses a second tip to probe again,
cycling to tune the measured value. This process is
repeated for each vessel to be measured. Where the
segment is not eligible for optimal height calibration, a
single tip is used to probe the base of the vessel and the
process proceeds as described in Section 7.1.3,
Automatic Height Calibration.
9. If “Require confirmation from user?” was selected, the
Status region of the form shows the measured values,
the calculated average, and the value determined as the
height calibration. This value can be saved using the
“Save” button, or the process at step 8 can be performed
again by selecting “Retry”. If “Require confirmation from