Playcraft Farm Sound Panel Insert R5, Installation Manual

Page: 264 / 314

IMPORTANT NOTES: Read First
www.playcraftsystems.com
For Customer Service Call
800.333.8519 (U.S.A.) or 541.955.9199 (International)
SECTIONAL SPIRAL SLIDE ASSEMBLY
INSTALLATION INSTRUCTIONS
Rev B
5/19/2021
1706-S
Page 1 of 12
Figure 1.1
See Installation Manual
Sections 09 Collars
Figure 1.2
Figure 1.4
Figure 1.6
Figure 1.7
Figures 1.3 & 1.5
(A)
Use liquid thread lock (such as Loctite
®
) with all threaded hardware.
Important:
Liquid thread lock (prior to
curing) helps to eliminate the common problem of "thread seizure" in stainless steel hardware by serving as a
lubricant during assembly.
(B) Do not pour concrete until the equipment is completely assembled, leveled and plumbed. Concrete must
be allowed to cure completely before using the equipment (at least 72 hours).
(C) Refer to Installation Manual for 09 Collars and 11 Socket Clamps installation instructions.
(D) For slides with an entry elevation of 48" [1219mm] or greater, the exit height must be between 7" [180mm]
and 15" [380mm] from finish grade. For slides with an entry elevation of less than 48" [1219mm], the exit
height must be less than 11" [279mm]. Exit region must always have a downward slope between 0° and 4°.
(E) An appropriate energy absorbing safety surface is required under and around all playground equipment.
Loose fill protective surfacing is shown only as an example for the purpose of this assembly instruction. Other
surfacing material may vary in thickness and/or compression depths. See free publication - The Handbook for
Public Playground Safety, Publication #325 at www.cpsc.gov for the surfacing appropriate for the fall height of
the equipment or consult your surfacing supply representative.
FIGURE 1
Sectional Spiral
Slide Assembly
NOTE : R5 Spiral Slide 72" configuration
shown. Other configurations will vary
slightly, but does not affect assembly.