Playcraft Farm Sound Panel Insert R5, Installation Manual

Page: 128 / 314

IMPORTANT NOTES: Read First
www.playcraftsystems.com
For Customer Service Call
800.333.8519 (U.S.A.) or 541.955.9199 (International)
SINGLE POST SWINGS
INSTALLATION INSTRUCTIONS
Rev O
7/31/2019
PC-2181
Page 1 of 11
See Footing Detail
Figure 1.8
Figures 1.1,1.2 & 1.3
Figure 1.7
Figure 1.4
Figure 1.5
Figure 1.6
See Installation Manual
Section PC-131410
Inclusive Swing Seat
AB
See Installation Manual
Sections R5-1847 Tree Top
or R5-1848 Oak Tree Top
(A) Use liquid thread lock (such as Loctite
®
) with all threaded hardware. Important: Liquid thread lock (prior to
curing) helps to eliminate the common problem of "thread seizure" in stainless steel hardware by serving as a
lubricant during assembly.
(B) Do not pour concrete until the equipment is completely assembled, leveled and plumbed. Concrete must be
allowed to cure completely before using the equipment (at least 72 hours).
(C) Important: Full bucket seat swings should be suspended from structures that are separate from those used
for other swings, or at least suspended from a separated bay of the same structure . According to the Handbook
for Public Playground Safety, Publication #325 at www.cpsc.gov.
(D) Refer to CPSC for appropriate swing spacing.
(E) Chain length should be adjusted (trimmed) so that the underside of the belt swing is no less than 12"
(Bucket Seat 24") from Finish Grade. See Recommended Swing Seat Heights.
(F) Important: Do not modify hanging position of ADA swings. (e.g. shortening chain, etc.)
(G) All bolt threads protruding beyond the nut must be cut and de-burred until end is smooth to the touch.
Sharp edges and/or points of any kind must be eliminated. A maximum of two threads may be exposed beyond
the end of the nut.
(H) An appropriate energy absorbing safety surface is required under and around all playground equipment.
Loose fill protective surfacing is shown only as an example for the purpose of this assembly instruction. Other
surfacing material may vary in thickness and/or compression depths. See free publication - The Handbook for
Public Playground Safety, Publication #325 at www.cpsc.gov for the surfacing appropriate for the fall height of
the equipment or consult your surfacing supply representative.
FIGURE 1
Single Post Swings
NOTE : 3 Bay 8' Height shown. Other
configurations will vary slightly, but
does not affect the assembly.
TREE TOP UPGRADE