Playcraft Farm Sound Panel Insert R5, Installation Manual

Page: 195 / 314

For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
DISC CLIMBER
INSTALLATION INSTRUCTIONS
Rev B
11/13/2014
1233
Page 4 of 5
Post as shown in Figure 1.2.
Detail. Secure Disc Climber Disc(s) to Disc Climber
Disc Climber Disc and position as shown in Footing
Refer to Top View for orientation of handles to top
(Factory Assembled)
Step 6
Step 7
Install Anchor Pin to Disc Climber Post and place
into footing hole as shown in Figure 5.
(See Notes A, B, & C)
Step 8
Fully tighten all fasteners according to the
"TIGHTENING TORQUE FOR HARDWARE"
section of the Installation Manual.
Step 9
Plumb and level entire component. Pour concrete
into footing hole. Allow at least 72 hours to cure
before using this equipment. (See Note B)
Step 10
Place required protective surfacing under and
around Disc Climber. (See Note D)
Step 5
(Factory Assembled)
FOR EACH ADDITIONAL DISC
Attach Disc Climber Disc to Disc Climber Disc as
shown in Figure 1.1. (See Note A)
Figure 1.1
DISC CLIMBER
DISC
Button Head Bolt
3/8" x 1-1/4"
Washer
3/8" x 7/8" O.D.
DISC CLIMBER
DISC
Figure 1.2
1/4"x 1-1/4" BH TR
Tek Screw
DISC CLIMBER
DISC
FIGURE 5
3/8" x 5-1/2"
3/8" Hex Nut
Hex Bolt
DISC CLIMBER
POST