0x1F0007A3 PiezoMike Mode
Used in: Motion in closed-loop operation (27)
Description:
Analog step-and-settle switched off at the end of a commanded mo-
tion?
If the parameter is set (1), step mode is not switched over to linear
mode at the end of motion. Makes sense for example, for applica-
tions where it is more important to reach the target position quickly
and where nanometer precision is less important.
Data type
INT
Command level
1
Item type
Axis
Source of data
PC software commands (
ments
Possible values
0
Analog step-and-settle at the end of a commanded motion
Commanded motion is done in step mode until the entrance window
is reached for linear mode (parameter
). Motion continues in linear mode
until the window defined around the target position has
been reached (parameter
). On-Tar-
get status is then set, if necessary after a delay time (pa-
1
No analog step-and-settle at the end of a commanded motion
Commanded motion is done in step mode until the window defined
around the target position has been reached. On-Target
status is then set directly, if necessary after a predefined
delay time.
10 PARAMETER REFERENCE
PZ285EN
‒
1/30/2019
206
M O T I O N | P O S I T I O N I N G