FASTCAM-APX RS Hardware Manual
-97-
Setting up Master Camera (That Outputs Sync Signal)
First decide the master camera that provides sync signal to the other camera, and
make necessary setting on it in the following manner:
1. Press the MENU key on the keypad to display the menu list.
2. Move the cursor by the U-D keys to [EXT-SYNC OUT] menu and press the ENTER
key to enter the selection.
3. Move the cursor up or down to select an output signal,
VSYNC POS
in this
example, and press the ENTER key.
4. Now the system has been set in a way that a sync signal (positive going) is output
from the EXT-SYNC OUT connector.
Setting up Slave Camera (That Receives Sync Signal)
Next, set up the input sync signal on the slave camera in the following manner:
1. Connect between the EXT-SYNC OUT of the master camera and the EXT-SYNC
IN of the slave camera with a BNC cable to feed the sync signal from the master
camera to the slave.
2. Make sure that the green LED (POWER LED) on the rear panel of the slave
camera blinks.
